True. I only tapped one wire with an “add-a-circuit“ and taps from the rear of the head lamp light assembly plug. Everything else is off the main battery to my separate fuse box With disconnect etc like you see in the pictures. Directly off the terminals, too so less they can say but I am...
Also when I was doing the initial normal first month add ins that all do…..
i needed to run the wires for my Radar Detector and Dash Cam Setup. This is one of my favorite mods Because everything comes out so clean. I did find a harness being unused in the ceiling with like 12 or 14 gauge...
Forgot to add these in. bed cover was one of the first mods. I went with the Retrax HD I think it’s called…. Third truck I have owned with it. Other than the loss of a little bed space, it hands down is one of the best hard retractable tonneaus. I would argue it is the best, but a bit pricy.
i have tied to stay away from the engine and tranny due to some of the mechanical issues some are having.
I have. Road trip from Ohio to Seattle and back to move a child back closer to home after first job out of college.
I would agree about where to stop. It can turn into a sickness. 😂
Few mods along the way. Wiring Splice, with room for additional Mods to connect too.
RC Dual Grille
RC Facia with LED DRLs and Turn Signals
New LED Turn Signal Bulbs
So I could see all this I added constant switched powered engine bay lighting.
I wanted good light and I do have a gravity switch but went with a simple, well made single pole switch that easily fit right into a somewhat discrete protected hole that was already there.
I went with A cheap LED...