2022 TB LT (Refresh) - AVS Aeroskin Lightshield

[johnnyh]

Well I can officially confirm the AVS Aeroskin Lightshield does NOT fit on the refresh models.. I was however able to use the light strip itself and mount it right under the hood in the open space above the Chevy bowtie. Ran wiring to the PRK LT fuse under the hood using a fuse tap. Little pricey for just the led light stripe itself with disregarding the bug shield but I ended up getting it for free thanks to an Amazon mess up

 

[scotman623]

Nice job my friend!! At least you found a way to use the lights that makes your truck look good..

 

[johnnyh]

Nice job my friend!! At least you found a way to use the lights that makes your truck look good..

Thanks brotha, still a little on the fence with it sitting so low but it’ll do for now atleast till one comes out that fits her

 

[Keller]

Just make sure both your tail lights are working when the light bar is on. I tapped into the parking light fuse and it disabled one of my tail lights.

 

[johnnyh]

Wow I didn’t even think about checking that, did you get a code/light on the dash or anything? I’ll go out and check them in a bit

 

[johnnyh]

Just make sure both your tail lights are working when the light bar is on. I tapped into the parking light fuse and it disabled one of my tail lights.

Taillights/brake lights seem to be good even tried cargo lights, I did make sure the fuse in the fuse tap for the led strip was a 20 and left the 15 in for the PRK LT could you of just maybe put the fuses in the tap backwards? I had to look it up 3 times and take a screenshot to remember which went where in the tap

 

[GETGONE]

For those that want a stick on LED strip without spending $200+ for the AVS light shield, I purchased this. I haven't installed it though. I bought it because I picked up an Aero Cab lighted piece minus the lights for $15. I found this but can't decide if I really want to install it or not.

5-Bar/Section Amber Raptor Style LED Hood Bulge Grille Light For Toyota Tundra | eBay

The marker light is flexible and designed to be IP67 resistant. Includes (1) amber LED raptor style hood scoop mount marker light designed to be flexible and IP67 water resistant. Fit 2014-2021 Toyota Tundra.

www.ebay.com

 

[DMV]

For those that want a stick on LED strip without spending $200+ for the AVS light shield, I purchased this. I haven't installed it though. I bought it because I picked up an Aero Cab lighted piece minus the lights for $15. I found this but can't decide if I really want to install it or not.

5-Bar/Section Amber Raptor Style LED Hood Bulge Grille Light For Toyota Tundra | eBay

The marker light is flexible and designed to be IP67 resistant. Includes (1) amber LED raptor style hood scoop mount marker light designed to be flexible and IP67 water resistant. Fit 2014-2021 Toyota Tundra.

www.ebay.com

How did this turnout?

 

[GETGONE]

I haven't installed it. I'm on the fence about adding grill lights.

 

[Jmzvet]

You been on that fence a long time

 

[GETGONE]

You been on that fence a long time

It's also been cold and wintery here in Michigan. Double side tape doesn't like to stick in the cold! My fingers hate wiring in cold weather too!

 

[Jmzvet]

All valid points