Are the Ready Lift recommended max tire and wheel sizes accurate?

[Bowtie]

I'm just about ready to pull the trigger on the Ready lift 2.0 SST kit along with a set of Fuel Clash 20x9 1mm offset wheels with Toyo 295/65/ R20 tires on my stock 2022 TB. I've chosen my set up based upon the Ready Lift max tire size recommendations on their web site.
I'm concerned about tire rub and I'm ok with a small wheel spacer if it's necessary for a clearance issue. For the most part I'm not looking to get into the whole trimming, mud flap delete process and simply want a set up with no rubbing issues.
Anyone here running a similar set up without inner fender or UCA rubbing issues? Thanks

 

[Stormin08]

run what they say, if you dont wan to trim or modify. you wont need to TRIM (metal usually) like others ...IF THE WEHEEL SPEC IS CORRECT>
based on what you have, a 35x12.50 should clear with fender liner pulling, and maybe a slight trim of some edges of mudflaps. Your biggest concern would the joint circle of the upper arm rubbing tire.

 

[Bowtie]

Contacting the UCA is definitely a concern. The Fuel Clash is a lip type of wheel with zero back space so I'm thinking that will help to avoid that issue.

 

[TGomez]

I installed the 2.0 SST UCA kit on my 2019. I’ve had it for about 3 years now. I kept my stock wheels and put Toyo open country RT 35s. I did have to add a wheel spacer because of the wider tire would hit the control arm. I added a 1.75 bora wheel spacer. I have not had any issues with the wheel spacer and I tow a car at least once a month. Hope this helps out

 

[2020ChevyNewbie]

TGomez did you have to do any cutting or trimming?

 

[TGomez]

I just removed the mud flap bracket and trimmed the mud flap and also cut the inside wheel well liner in the front. Nothing to hard to do. Here are 2 pictures that may give you an idea.

TGomez did you have to do any cutting or trimming?

I just removed the mud flap bracket and trimmed the mud flap and also cut the inside wheel well liner in the front. Nothing to hard to do. Here are 2 pictures that may give you an idea.

 

[Bowtie]

View attachment 7905View attachment 7902View attachment 7903View attachment 7904View attachment 7907View attachment 7908View attachment 7909I installed the 2.0 SST UCA kit on my 2019. I’ve had it for about 3 years now. I kept my stock wheels and put Toyo open country RT 35s. I did have to add a wheel spacer because of the wider tire would hit the control arm. I added a 1.75 bora wheel spacer. I have not had any issues with the wheel spacer and I tow a car at least once a month. Hope this helps out View attachment 7902

You're truck looks awesome. Just the right amount of poke in my book.
I can live with the amount of trimming that you did, and a little wheel spacing if needed. I like the fact that you still retained the splash gaurd. Thanks for the pics.