JeffC
New member
Shock is set on 3rd highest setting, can see 1st in picture, I can feel 2nd grove.
Truck sitting in driveway, driveway has some pitch to it.
Truck sitting in driveway, driveway has some pitch to it.
2020 Trailboss Eibach Pro lift
- Thread starter JeffC
- Start date
Flowgrown
New member
Sorry for a late reply and update. I do have my eibach pro truck 2 kit installed and front coil overs are maxed out. I asked eibach about a small spacer on the bottom or top and im talking half in if that which I know could be a lot on suspension. I'm a little over an inch lower in the front from the back i don't notice much in height change from stock because I didn't measure like an idiot lol. The shop said I was just over an inch higher. Just want my perfect level back so next option is smaller block in rear unfortunately. Rides pretty good ill say that but may end up getting a different kit and selling these for a decent price depending on when I do. Should have gone with a 3 inch lift level but here I am. Haven't taken a picture from the side yet but will soon.
Attachments
Stormin08
Well-known member
grab a shot looking straight on at the axle shaft in front...it looks like you have room to add a lower spacer.
you should have only gained .5" lift in front...as an old school hot rodder, we never leave nothing alone, nor do we stop until we love it.,...
as much as i dont recommend things, we still want what we want....i run a lower spacer, along with one thick grade 8 washer to dial in my front height
you should have only gained .5" lift in front...as an old school hot rodder, we never leave nothing alone, nor do we stop until we love it.,...
as much as i dont recommend things, we still want what we want....i run a lower spacer, along with one thick grade 8 washer to dial in my front height
Flowgrown
New member
This is just the passenger side. Is that the type of Pic you meant?
Attachments
Stormin08
Well-known member
Yes, so it appears
1. You have room to add a lower spacer
2. is the shock bolted UP from the bottom ?
That doesn't appear correct, the lower Tbar for the shock should be ON the control arm.
Is that is the case, start there and see how it sits
1. You have room to add a lower spacer
2. is the shock bolted UP from the bottom ?
That doesn't appear correct, the lower Tbar for the shock should be ON the control arm.
Is that is the case, start there and see how it sits
Flowgrown
New member
I'll be honest im not sure what you are referring to in reference to bolted up and the tbar lol. I'm fairly new to anything suspension always had stock vehicles outside of some sound systems and a few other mods. To me it looks like my cv's and ball joints are good on another half inch of level to the front but being a coil over just don't know how that plays into it.
Last edited:
Stormin08
Well-known member
your front shock appear to have the lower mount UNDER the control arm...
if so, swap that mounting tot he top side...
the lower shock mount has an eye with bushings, and a bad passing through for the bolts...that is your lower T-bar
snap a better pic looking down at the lower shock mounting
if so, swap that mounting tot he top side...
the lower shock mount has an eye with bushings, and a bad passing through for the bolts...that is your lower T-bar
snap a better pic looking down at the lower shock mounting
