What did you do to your Trailboss today? 🛠️

[Stormin08]

would be nice if it had a single unlock bar.

 

[Ryanj5049]

Swapped out factory storage for an DU-HA under rear seat lockable storage … American made product
View attachment 19502
View attachment 19504
View attachment 19505

I'd do just this if i didn't need the rear room for my dogs!!!

 

[JWright82]

Swapped out factory storage for an DU-HA under rear seat lockable storage … American made product
View attachment 19502
View attachment 19504
View attachment 19505

I like this option, thanks for posting. Beats the brakes off the OEM accessory stuff.

 

[JP20TB]

I'd do just this if i didn't need the rear room for my dogs!!!

Yeah my mutts are a must so it’s easily removed ….

 

[Ryanj5049]

Yeah my mutts are a must so it’s easily removed ….
View attachment 19515

GOOD MAN!!!

 

[gcan]

Installed the mud flap delete, rough country soft bed cover, blacked out Z71 emblems and buck up LED pods. Waiting on the rear fender liners and to install the 1.5 inch Rough Vountry level kit.View attachment 19486View attachment 19484View attachment 19485

I'm thinking about changing out my Z71 emblems......wanting to go from black to like yours black and red. Where did you get this and was it hard to do? TIA

 

[Mike Edwards]

I added a flex fuel sensor and set it up in the ecm.

I was already out of fuel system with just the pulley that magnuson supplies in the 5.3 kit. Now that I know this works I'll need a lot more fuel to supply full e85. I already have a set of LT4 injectors and hpfp ready to go in. I'm not sure what to do with the low side fuel system yet. The Escalade V pump is on backorder and may not be enough for full ethanol anyway. I may make my own auxiliary pump.

 

[Stormin08]

just curious what fuel you running. the sensors is picking up 47% E ?

 

[Ryan]

Got smacked today by a new driver and only had her learners permit. Only $6400 in damage

 

[JP20TB]

Got smacked today by a new driver and only had her learners permit. Only $6400 in damage

Sorry bro… but on the positive side you have an excuse to get a aftermarket bumper …probably cheaper than what GM is charging for their OEM replacement

 

[Mike Edwards]

I put a five gallons of e85 in with probably 2 gallons of 93 (e10) just to be sure the sensor and tune corrected the air fuel ratio. If it didn’t I wanted to be able to dilute it with 15 more gallons of 93.

The sensor picks up whatever the ethanol mixture is. It corrects the stoich air fuel ratio (14.7:1 for 0% to 9.8:1 for 85%) and adjusts timing depending on what’s in the alcohol timing table.

 

[Stormin08]

i understand the sensor, wanting add that to my list (just to have the choice)...the 47% looked od. but the mix explains that.

i typically run my Harley to nearly empty before topping off with E85.

 

[Mike Edwards]

i understand the sensor, wanting add that to my list (just to have the choice)...the 47% looked od. but the mix explains that.

i typically run my Harley to nearly empty before topping off with E85.

It’s not as easy or cheap on a global b (23+) truck. They don’t have the logic in the firmware and it has to be added as a patch by dsx tuning.

 

[Eddie]

Put on a cold air inductions intake with an updated JET mass air flow sensor and the pulsar LT.

Don’t mind the dirty engine bay!

 

[JP20TB]

Put on a cold air inductions intake with an updated JET mass air flow sensor and the pulsar LT.

Don’t mind the dirty engine bay!

View attachment 19568

How’s that new mass flow air sensor working out ..: any noticeable improvement?